Mechanical Fuel Pump Kit
The Mechanical Fuel Pump attaches directly to the VW engine case. Stands about 3.5" tall. Kit contains fuel pump, pushrod, pushrod housing. Note: you need a distributor drive pinion gear kit and distributor housing to use this.	Price . . . $31.95.

Main Fuel Valve

This Main Fuel Valve is made from brass and has a 1/4" pipe thread on one end and a barbed fitting on the other for 1/4" I.D. fuel line. Price . . . $8.95.

Transfer Fuel Valve
This Transfer Fuel Valve is made from light weight fuel proof plastic and weighs approximately 1 ounce. Primary use is auxiliary fuel tank on/off selector switch. Price . . . $3.95.

Primer
Our Primer is for use on all carburetors. Price . . . $12.95.

Great Plains Gascolator

This Gascolator is a high quality, low cost fuel filter and water strainer. It should be installed at a low point in the fuel system, below the fuel tank to trap any water that may accumulate so it can be drained. The gascolator has a 10 micron fuel filterand an 1/8" pipe thread outlet for a quick fuel drain valve (not included). If you are using a fuel pump, the pump should be installed between the carb and the gascolator. Price . . . $29.95. Curtis Quick Drain Valve for use on Gascolator . . . $11.75.

Fiberglass Reinforced Plastic Fuel Cap and Neck

These fuel caps are an excellent choice for those making a fiberglass fuel tank. This high quality unit is flush mounted with a screw in cap with a buna-rubber seal ring. It has a 1.5" I.D. fuel inlet. The neck can be cut off to desired length. Held in place with epoxy and flox or sealing screws. Used on many homebuilts: KR's, EZ's, etc. Price . . . $14.95.

Go to Home Page Here!

To place an order: Call us at 1-800-922-6507
Questions at 1-402-493-6507
Fax us at 402-493-3846.
Inquiries can also be directed to:
gpasc@earthlink.net