Great Plains Aircraft
Supply Co.



INSTALLATION INSTRUCTIONS FOR THE STEEL CAM PLUG



1. This cam plug must be sized before installation. Failure to do so will result in a case leak.

2. Install cam plug in engine case without sealant. Bolt the case halves together and squash plug.

3. Un-bolt case halves and rotate the cam plug 90 degrees and bolt case halves together again. Repeat this procedure at least 4 times.

Note: You only need to put nuts and washers on the two rear large studs when doing this. One is towards the top of the case, the other is towards the bottom.


Go back to Cam Plug Order Info


Go back to the Shopping Cart Index


Go back to Instruction Index